Mettler Toledo M400 Dokumentacja Pobierz pdf (Strona 43)

Transmitter Multiparameter M400 43

Printed in Switzerland 52 121 378

8.3 Analog Outputs

(PATH: Menu / Conﬁgure / Analog Outputs)

Enter conﬁguration mode as described in Section 8.2.

Press the [ENTER] key to select this Menu, which lets you conﬁgure the 4 Analog Outputs.

Once analog outputs have been selected, use the  and  buttons to navigate between

conﬁgurable parameters. Once a parameter is selected, its setting can be selected per the

following table:

When an Alarm Value is selected, the analog output will go to this value if any alarm condition

occurs.

Parameter Selectable Values

Aout: 1, 2, 3 or 4 (default is 1)

Measurement: a, b, c, d or blank (none) (default is blank)

Alarm Value: 3.6 mA, 22.0 mA or Off (default is off)

The Aout type can be Normal, Bi-Linear, Auto-Range or Logarithmic. The range can be 4–20mA

or 0–20mA. Normal provides linear scaling between the minimum and maximum scaling l

imits and is the default setting. Bi-Linear will also prompt for a scaling value for the mid-point

of the signal and allows two different linear segments between the minimum and maximum

scaling limits.

Enter the minimum and maximum Value of Aout.

If Auto-Range was selected then Aout max1 can be conﬁgured. Aout max1 is the maximum

value for the ﬁrst range on Auto-Range. The maximum value for the second range on Auto-

Range was set in the previous menu. If Logarithmic Range was selected, it will also prompt

for the number of decades as ”Aout1 # of Decades =2”.

The value for the Hold mode can be conﬁgured to hold the Last value or can be set to a Fixed

value.

Pressing the [ENTER] key again will bring up the Save Changes dialog. Selecting No will

discard the entered values and return to the measurement display screen, selecting Yes will

save changes made.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 87 88

Brak uwag

Mettler Toledo M400 Dokumentacja Strona 43